Sumeet Thapar, . Designation Director at THAPAR SPINNING MILLS LIMITED.
Aseem Thapar, . Designation Director at THAPAR SPINNING MILLS LIMITED.
Anil Kumar Thapar, . Designation Director at THAPAR SPINNING MILLS LIMITED.
Hardeep Singh, . Designation Director at THAPAR SPINNING MILLS LIMITED.
Located at B- 47, PHASE VII, FOCAL POINT, LUDHIANA, Punjab. .

Searching for a company ?

Find all the information about a company you are looking for!

THAPAR SPINNING MILLS LIMITED

About Thapar Spinning Mills Limited
Thapar Spinning Mills Limited was registered at Registrar of Companies ROC Chandigarh on 21 December, 1990 and is categorised as Company limited by shares and an Non-government company.
Thapar Spinning Mills Limited's Corporate Identification Number (CIN) is U17115PB1990PLC010934 and Registeration Number is 010934.

Thapar Spinning Mills Limited registered address on file is B- 47, PHASE VII, FOCAL POINT, LUDHIANA - , Punjab, India.

Thapar Spinning Mills Limited currently have 3 Active Directors / Partners: Aseem Thapar, Anil Kumar Thapar, Hardeep Singh, and there are no other Active Directors / Partners in the company except these 3 officials.

Thapar Spinning Mills Limited is involved in Activity and currently company is in Strike Off Status.

Company Name THAPAR SPINNING MILLS LIMITED
CIN U17115PB1990PLC010934
Registration Date 21 December, 1990
Registeration No. 010934
RoC ROC Chandigarh
State Punjab
Registered Address B- 47, PHASE VII, FOCAL POINT, LUDHIANA, Punjab, India
Category Company limited by shares
Sub Category Non-government company
Authorised Capital Rs 81000000 INR
PaidUp Capital Rs 30056290 INR
Company Class Public
Last Annual General Meeting Date 31 December, 2020
Date of Balance Sheet 31 March, 2020
Is Company Listed Not Listed
Company Status Strike Off
Active Directors
Director Name
Aseem Thapar
Anil Kumar Thapar
Hardeep Singh
Resigned Directors
Director Name
Sumeet Thapar
Index of Charges
Asset Name Amount Creation Date Modification Date Status
No Charges found

Are you owner of this company?

Problem with this data ?

Click here