Vikas Kumar, . Designation Director at G VENTURE TECHNOLOGY PRIVATE LIMITED.
Gyanti Panchdev Patel, . Designation Director at G VENTURE TECHNOLOGY PRIVATE LIMITED.
Located at 92-BE-4 1ST FLOOR,UDYOG VIHAR, SEC.82, NEAR KEND RIYA, NOIDA, Uttar Pradesh. .

Searching for a company ?

Find all the information about a company you are looking for!

G VENTURE TECHNOLOGY PRIVATE LIMITED

About G Venture Technology Private Limited
G Venture Technology Private Limited was registered at Registrar of Companies ROC Kanpur on 28 December, 2012 and is categorised as Company limited by shares and an Non-government company.
G Venture Technology Private Limited's Corporate Identification Number (CIN) is U72300UP2012PTC054389 and Registeration Number is 054389.

G Venture Technology Private Limited registered address on file is 92-BE-4 1ST FLOOR,UDYOG VIHAR, SEC.82, NEAR KEND RIYA, NOIDA - , Uttar Pradesh, .

G Venture Technology Private Limited currently have 2 Active Directors / Partners: Vikas Kumar, Gyanti Panchdev Patel, and there are no other Active Directors / Partners in the company except these 2 officials.

G Venture Technology Private Limited is involved in Activity and currently company is in Active Status.

Company Name G VENTURE TECHNOLOGY PRIVATE LIMITED
CIN U72300UP2012PTC054389
Registration Date 28 December, 2012
Registeration No. 054389
RoC ROC Kanpur
State Uttar Pradesh
Registered Address 92-BE-4 1ST FLOOR,UDYOG VIHAR, SEC.82, NEAR KEND RIYA, NOIDA, Uttar Pradesh
Category Company limited by shares
Sub Category Non-government company
Authorised Capital Rs 2500000 INR
PaidUp Capital Rs 100000 INR
Company Class Private
Last Annual General Meeting Date 30 September, 2022
Date of Balance Sheet 31 March, 2022
Is Company Listed Not Listed
Company Status Active
Active Directors
Director Name
Vikas Kumar
Gyanti Panchdev Patel
Resigned Directors
Director Name
Record not found
Index of Charges
Asset Name Amount Creation Date Modification Date Status
No Charges found

Are you owner of this company?

Problem with this data ?

Click here