Venkoba Rao Rajendra Kumar, . Designation Director at GEAR DESIGN AND ROBOTICS PRIVATE LIMITED.
Vyasraj Joshi, . Designation Director at GEAR DESIGN AND ROBOTICS PRIVATE LIMITED.
Located at PLOT NO P-84 DII BLOCK NEAR KSB CHOWK MIDC CHINCHWAD, PUNE, . .

Searching for a company ?

Find all the information about a company you are looking for!

GEAR DESIGN AND ROBOTICS PRIVATE LIMITED

About Gear Design And Robotics Private Limited
Gear Design And Robotics Private Limited was registered at Registrar of Companies ROC Pune on 11 April, 2017 and is categorised as Company limited by shares and an Non-government company.
Gear Design And Robotics Private Limited's Corporate Identification Number (CIN) is U93098PN2017PTC169849 and Registeration Number is 169849.

Gear Design And Robotics Private Limited registered address on file is PLOT NO P-84 DII BLOCK NEAR KSB CHOWK MIDC CHINCHWAD, PUNE - , , .

Gear Design And Robotics Private Limited currently have 2 Active Directors / Partners: Venkoba Rao Rajendra Kumar, Vyasraj Joshi, and there are no other Active Directors / Partners in the company except these 2 officials.

Gear Design And Robotics Private Limited is involved in Activity and currently company is in Active Status.

Company Name GEAR DESIGN AND ROBOTICS PRIVATE LIMITED
CIN U93098PN2017PTC169849
Registration Date 11 April, 2017
Registeration No. 169849
RoC ROC Pune
State Maharashtra
Registered Address PLOT NO P-84 DII BLOCK NEAR KSB CHOWK MIDC CHINCHWAD, PUNE
Category Company limited by shares
Sub Category Non-government company
Authorised Capital Rs 100000 INR
PaidUp Capital Rs 100000 INR
Company Class Private
Last Annual General Meeting Date 30 November, 2021
Date of Balance Sheet 31 March, 2021
Is Company Listed Not Listed
Company Status Active
Active Directors
Director Name
Venkoba Rao Rajendra Kumar
Vyasraj Joshi
Resigned Directors
Director Name
Record not found
Index of Charges
Asset Name Amount Creation Date Modification Date Status
No Charges found

Are you owner of this company?

Problem with this data ?

Click here